20 years focusing on recycling

  • +86-0512-58810860

Plastic Scrap Grinder Operating Procedures And Preparation

Views: 901 Author: Site Editor Publish Time: 2022-10-11 Origin: Site

Plastic scrap grinder refers to the crushing of a variety of plastic and rubber plastic profiles, tubes, rods, wire, film, waste rubber products. Granules can be directly for extrusion, as the production of raw materials.

 

Plastic grinder using alloy steel blades, long life; at the same time, the machinery using the separation design, easy to repair and cleaning, and has a double structure, equipped with sound insulation materials, low noise, knife shaft seat after strict balance test, machine base and equipped with four wheels, easy to move.

Plastic-Scrap-Grinder-Operating-Procedures-And-Preparation.jpg


I. Operating procedures

   Article 1 The driver of the crusher must be trained to achieve "three understandings" (understand the structure, understand the performance, understand the principle), "four will" (will use, will maintain, will maintain, will deal with faults), after passing the training examination and obtaining a certificate of competence, before being allowed to operate.

 

  Article 2  with the working face scraper conveyor driver, transport lane belt conveyor driver close cooperation, unified signal contact, in order to open, stop open. There are large pieces of coal, gangue in the crusher of the inlet pile overflow, should stop the work and face scraper conveyor operation. If large pieces of coal, gangue can not enter the crusher or have metal objects, must stop processing.


Second, the preparation work

  1, Tools: spanner, pliers, screwdriver, small hammer, shovel, etc; 

  2, the necessary spare parts: all kinds of short joint chain, chain ring, bolts, nuts, crusher's insurance pins, etc.;

    3, Lubricating oil, turbine oil

 

Inspection and treatment

  1, The coupling parts of the motor, reducer, hydraulic coupling, head and tail of the machine must be complete, intact and tightened. The speed reducer and hydraulic shaft joint should be free of oil seepage and leakage, and the oil quantity should be appropriate.

  2, the signal must be sensitive and reliable, no signal is not allowed to start the machine. Spray sprinklers should be in good condition.

   3, The power supply cable and operation line must be hung neatly, without the phenomenon of extrusion;

   4, the head near the coal, gangue, debris and motor, reducer coal dust must be cleaned clean;

   5, the working surface scraper conveyor head and transfer machine tail lap to appropriate;

   6, scraper chain plate tight to be moderate, scraper and screws must be complete tightening;

   7, the transfer machine walking trolley must be smooth and reliable;

   8, the transfer machine bridge part of the case when the machine is opened, the operation of each department should be no abnormal sound, scraper, chain, connecting ring should be no twisting and turning, twisting twist, bending deformation;

   9, the plastic grinder, crusher at the roadway support must be intact, solid.

   10, the plastic grinder safety protection network and protection devices, to ensure that no deformation does not fail, safe and reliable;

   11, the plastic grinder at the roadway support must be intact, solid.